Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 101)

COMMUNICATIONS SETUP

IP Address Setup

350-7951 Quadra User’s Guide 93

. . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

IP ADDRESS SETUP

The following topics are discussed in this section:

• Introduction to IP Addresses

• IP Address Setup via Serial Port

• IP Address Setup via Ethernet

INTRODUCTION TO

. . . . . . . . .

IP ADDRESSES

When connecting systems via Ethernet, the setup of communications

parameters is automatic. However, because this is a network connection, a

unique address (known as the IP address) is required.

For proper operation, Quadra requires a fixed IP address (also known as a

“static” IP address). At the factory, Quadra is programmed with a default IP

address (192.168.1.200), but this address must be changed if you want to use

your Quadra on a network.

S Recommendation: If you want to use Quadra on a Local Area

Network (LAN), change the unit’s IP address before putting it on the

network. This can be accomplished in one of two ways:

~ Use the serial port to change the unit’s IP address. Refer to

the “IP Address Setup via Serial Port

” section below.

~ Connect Quadra directly to a PC using Quadra’s Ethernet

port. Refer to the “IP Address Setup via Ethernet

” section

for details.

IP ADDRESS SETUP

. . . . . . . . .

VIA SERIAL PORT

Use the following steps to change Quadra’s IP address using the serial port:

1. Connect Quadra as outlined in the “RS-232 Serial Control Setup

”

section in Chapter 2.

2. In the Hyperterminal window, type:

IPADDR

... and press Enter.

Quadra responds with the current IP address. Make a note of the

address before proceeding with the next step.

3. Type IPADDR followed by a space, and the new IP address (as

provided to you by your network administrator).

S Example: If the new IP address is 192.168.100.15, type:

IPADDR 192.168.100.15

... and press Enter.

Important Consult your network administrator to obtain a valid IP

address before commencing the network setup procedure.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 131 132

Commentaires sur ces manuels

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 101

Commentaires sur ces manuels