Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 71)

COMMAND LINE INTERFACE

Command Summary

350-7951 Quadra User’s Guide 63

. . . . .

OUTPUT COMMANDS DESCRIPTIONS

The table below lists all output commands, their arguments and detailed

descriptions.

Table 4-5.

Output Commands Descriptions

Command Arguments Description

OutPutENable <output # | ALL> [ON |

OFF] [duration]

Enables or disables the specified output signal. When

used with the optional duration parameter, the output

fades to black for the specified duration. The duration

parameter has a range of 0.1…128.0 seconds.

Default: ON, duration = 1.0

OutPutREFerence <output # | ALL> [EXT

| INT]

Selects the output timing reference for the specified

output.

• When INT is selected, the output is locked

to an internally generated clock (also known

as Free Run mode).

• When EXT is selected, the output is locked

to the input signal connected to input #1.

Default: INT

OutPutTiMing <output #> [<hfp> <hs>

[<hfreq> <sync>

<hpol> <vpol> <il>]] |

[HFP | HS | HBP |

HACT | VFP | VS | VBP

| VACT | HFREQ |

SYNC | HPOL | VPOL |

IL] [value]]

This advanced mode sets the output timing by output

channel and by parameter. The command supports the

ability to set all parameters at once, or the ability to set

(or query) the status of individual parameters.

Refer to the “Timing Parameters

” section for details

on all timing parameters.

OutPutTiMing

INTeractive

<output #> Enters the interactive output adjustment mode for the

selected output channel. This function enables you to

optimize the output timing values to better suit your

display. Once in the interactive mode, a white box

appears on the output display.

Starting with the upper-left corner of the box, use these

keyboard controls:

i = move up j = move left

m = move down l = move right

With the upper-left corner properly adjusted, address

the lower-right corner next by using these keyboard

controls:

I = move up J = move left

M = move down L = move right

With the image properly adjusted, quit the utility:

q = quit

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 131 132

Commentaires sur ces manuels

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 71

Commentaires sur ces manuels