Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 33)

INSTALLATION AND SETUP

System Timing

350-7951 Quadra User’s Guide 25

. . . . .

• The Input Interactive function enables you to adjust each input’s

timing interactively. Interactive timing applies only to graphics inputs

(not composite or S-Video sources). This method is described below.

Use the following steps to adjust input timing interactively. The procedure

takes you through the complete adjustment for one input (including naming and

saving settings), and then asks you to repeat steps for each remaining input.

1. Ensure that you have a working serial (or Telnet) connection to

Quadra (depending upon your configuration).

2. To perform interactive input timing, ensure that the desired input

sources are connected to the appropriate Quadra input modules.

Refer to the “Installation

” section for instructions.

3. Select the RGB or DVI input type as required for each input using the

“INputSouRCe

” command.

Type:

INSRC <input#> [RGB | DVI | YUV | COMPOSITE1 |

COMPOSITE2 | SVIDEO]

Enter

Please note the following points regarding the command’s arguments:

~ When using an RGB graphic input connected to the RGB

connector, select the RGB argument.

~ When using a digital video input connected to the optional

DVI connector, select the DVI argument.

S Example: If a digital (DVI) source is connected to input 2,

type INSRC 2 DVI and press Enter.

4. To begin the input timing procedure, type:

RSR <input#> Enter

This action resets the selected input and ensures that there is no image

zooming or cropping.

5. To time the input interactively, type:

INI <input#> Enter

A white box appears over the selected full screen input.

S Example: To adjust input 1 interactively, type:

INI 1

6. Starting with the upper-left corner of the image, use the keyboard

controls listed below to position the image within the white frame.

The goal is to position the corner for maximum image visibility. Note

that these adjustment commands are case sensitive.

i = move up j = move left

m = move down l = move right

Note These commands are all lower case.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 131 132

Commentaires sur ces manuels

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 33

Commentaires sur ces manuels