Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 22)

INSTALLATION AND SETUP

Installation

350-7951 Quadra User’s Guide 14

. . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

INSTALLATION

This section provides Quadra installation instructions. All connections are

made to the rear of the Quadra chassis. Refer to Figure 2-2

for the location of

each connector.

Use the following steps to install the Quadra:

1. Connect Power — Connect a power cord to the AC Power Connec-

tor. Quadra is equipped with a universal, 100-264 V, 50-400 Hz

power supply.

2. Connect Inputs — Connect the desired video and/or computer

sources to input channels 1 through 4. Please note the following points

regarding the various input formats:

~ Composite input — use a standard BNC cable.

~ S-video input — this input can be used to connect S-Video

or an additional composite video signal.

 To connect an S-Video signal, use a standard 4-pin

mini-DIN S-Video cable.

 To connect a composite video signal, use a mini-

DIN to BNC adapter, or a mini-DIN to phono

adapter cable. Connect the composite video signal

to the “Y” channel.

~ RGB / YP

input — use a standard VGA cable with a 15-

pin male D-sub connector. This connector supports 3, 4 or 5

wire connections. In Appendix C, refer to the “High

Resolution Analog Connector” section for pinouts.

~ Digital input (optional) — use a standard DVI cable. In

Appendix C, refer to the “DVI-I Connector

” section for

pinout information.

Remember that for each channel, a source can be connected to each

input (composite, S-Video, RGB and digital), but only one input can

be routed to a channel’s output. You can choose which input to

process by using the “INputSouRCe

” command.

Refer to Chapter 4, “Command Line Interface

” for a complete

description of Quadra commands.

3. Connect Channel Outputs — Using DVI-I interconnect cables,

connect channel outputs 1, 2, 3 and 4 to the desired destination

displays. Please note:

~ To connect to a DVI capable monitor, use a standard DVI

interconnect cable.

Note Ensure that Quadra is rack mounted before continuing.

Refer to the “Rack Mounting

” section for instructions.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 131 132

Commentaires sur ces manuels

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 22

Commentaires sur ces manuels