Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 18)

INSTALLATION AND SETUP

Front Panel

350-7951 Quadra User’s Guide 10

. . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

FRONT PANEL

The figure below illustrates a front panel view of the Quadra.

Figure 2-1. Quadra

Front Panel View

Descriptions of each control and indicator are provided below:

1) Alarm LED

The Alarm LED glows solid amber when the Quadra’s internal

electronics have exceeded the maximum internal temperature of 60

degrees Celsius. Note that this is a warning only, and users should

take corrective action to avoid damage to the unit.

2) Ethernet Activity LED

The Ethernet Activity LED blinks green when there is data traffic

over the Quadra’s Ethernet connection.

3) Ethernet Link LED

The Ethernet Link LED glows solid green when there is a valid

Ethernet connection between Quadra and another Ethernet device.

Note that if an RS-232 connection only is used, this LED will be off.

4) Reset Button

Press the Reset Button to perform a hard reset. Use an unfolded

paper clip to press the button, which is located inside the small access

hole. When pressed, systems parameters are unchanged (this is

equivalent to cycling the power).

5) Comms Default Button

Press the Communications Default Button to reset the IP address

to the factory default (192.168.1.200) and reset the RS-232 serial

port to 9600 baud (use and unfolded paper clip to actuate the switch).

6) AC Power Switch

Use the AC Power Switch to turn the Quadra on and off. When the

unit is on, the LED inside the switch glows red.

Alarm Activity Link

4 5 6

Quadra

1 2

B SPECTRUM

1) Alarm LED 3) Ethernet Link LED 5) Comms Default Button

2) Ethernet Activity LED 4) Reset Button 6) AC Power Switch

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 131 132

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 18