Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 60)

350-7951 Quadra User’s Guide 52

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

COMMAND LINE INTERFACE

This chapter discusses Quadra control commands that provide access to all of

the unit’s functions. The following topics are discussed:

• Control Overview

• Command Format

• Command Set List

• Command Summary

• Timing Parameters

• Factory Timing List

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

CONTROL OVERVIEW

Quadra may be controlled externally via RS-232, or via the unit’s Ethernet

10/100BASE-T port, as shown below.

Figure 4-1. Quadra

Control Methods

Quadra’s Command Set provides full system control, and with few exceptions,

all commands can be issued using either the serial port or the Ethernet port

(using a Telnet session). Exceptions are noted in the command descriptions.

Remember that control via Ethernet requires a connection using Quadra’s IP

address. In Chapter 2, refer to the “System Control Setup

” section for

instructions.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 131 132

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 60