Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 26)

INSTALLATION AND SETUP

System Control Setup

350-7951 Quadra User’s Guide 18

. . . . .

ETHERNET

. . . . . . . . .

CONTROL SETUP

Ethernet control enables you to use a Telnet session to control Quadra using a

command line interface. Quadra includes an internal Telnet server which

works with standard Telnet clients. A Telnet client is included as a standard

item with Windows

operating systems.

Use the following steps to control Quadra via Ethernet:

1. Ensure that Quadra’s Ethernet port is connected to your PC by one of

two methods:

~ Peer-to-peer connection — Quadra is connected directly

to your PC, using an Ethernet crossover cable. In Appendix

C, see the “Ethernet Connector

” section for details.

~ Network connection — Quadra is connected to your

LAN, Ethernet hub or Ethernet switch using a standard

Ethernet cable.

2. On your PC, launch a command window by clicking Start > Run. In

the Run Dialog, type:

cmd

…

and click OK.

3. In the command window, type:

telnet <ipaddress> 8000

…

where <ipaddress> represents the current IP address of your

Quadra and 8000 represents the communications port.

~ If you are connecting peer-to-peer and you have not changed

Quadra’s IP address, use 192.168.1.200, Quadra’s default

IP address.

~ If you are connecting peer-to-peer or via network, and you

do not know Quadra’s IP address (or if you want to change

the IP address), please refer to the “IP Address Setup

”

section in Appendix B.

Note If your system cannot locate the Telnet client during the

following procedure, there is a most likely a “path”

problem. Using Windows Explorer on your PC, search for

for “Telnet.” Once located, create a desktop shortcut to it.

Important Please note the following important points:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 131 132

Commentaires sur ces manuels

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 26

Commentaires sur ces manuels