Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 129)

TECHNICAL SPECIFICATIONS

Parameter Storage

350-7951 Quadra User’s Guide 121

. . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

PARAMETER STORAGE

This section describes the categories of settings that are stored in Quadra, and

how these settings are stored and retrieved.

The following topics are discussed:

• Factory Defaults

• System Configuration

• User Configuration

• Settings Export/Import

• System State Values

• Timing Presets

FACTORY

. . . . . . . . .

DEFAULTS

Quadra is shipped from the factory with pre-configured settings (parameters)

known as Factory Defaults. As soon as you begin to use the system, these

default settings will be replaced with your new settings.

New settings are automatically stored by Quadra in non-volatile memory. In

this manner, when you next turn on the unit, it will operate with the same

settings as the last time the unit was used (even if you had turned off the power).

If you want to return to the factory settings, use the

RestoreFactoryDefaults

command.

SYSTEM

. . . . . . . . .

CONFIGURATION

When you turn on Quadra power, the unit automatically loads settings for all

controls from non-volatile memory. This enables Quadra to function in the

same way as before power was turned off. This information, known as the

“System Configuration,” is stored automatically in non-volatile memory.

USER

. . . . . . . . .

CONFIGURATION

Quadra enables you to save your own set of default settings. This allows you to

override the current settings and set up the unit in a way that you have

previously defined. The

SAVECONFIGguration command provides a manual

way to save the current system settings into non-volatile memory. The settings

may then be loaded at any time using the

RECALLCONFIGuration command.

This is equivalent to using the

RestoreFactoryDefaults command, but using your

own set of default values instead of the factory defined defaults.

SETTINGS

. . . . . . . . .

EXPORT/IMPORT

In addition to storing settings internally in non-volatile memory, Quadra

provides the ability to store settings to an external device such as a PC. The

settings are stored in a text file that can be exported to (or imported from) the

external device using the SETTINGSEXPORT

and SETTINGSIMPORT

commands. This file can be generated to contain all system settings, or a subset

Note Restoring factory defaults will not affect the IP address

settings of your Quadra.

1 2 ... 124 125 126 127 128 129 130 131 132

Commentaires sur ces manuels

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 129

Commentaires sur ces manuels