Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 23)

INSTALLATION AND SETUP

Installation

350-7951 Quadra User’s Guide 15

. . . . .

~ To connect to a monitor with an analog RGB input, use an

adapter that converts from the DVI connector directly to a 15-

pin D-sub connector. This adapter is provided as a standard

item with your Quadra. As an alternative, standard cables are

readily available to convert from the DVI connector to either

15-pin D or BNC connectors.

Remember that each output connector supports both analog and DVI

signals. For a selected output channel, both the analog and digital

outputs can be used simultaneously, however, only one output

resolution can be set.

In Appendix C, refer to the “DVI-I Connector

” section for detailed

wiring instructions for channel output connectors.

4. Select a Control Method — either RS-232 or Ethernet. Both

methods use a command line interface:

~ Serial Control — To control Quadra using a terminal

emulation program (such as Hyperterminal or Procomm),

connect the COM port of your computer (or other terminal

control device) to Quadra’s RS-232 serial port. A straight

through cable (typically 9-pin male to female with one-to-one

wiring) will be required.

In Appendix C, refer to the “RS-232 Connector

” section for

information on RS-232 connection parameters.

Please continue with the “System Control Setup

” section.

~ Ethernet Control — To control Quadra over a network,

connect an Ethernet cable (from your LAN, Ethernet hub or

switch) to Quadra’s 10/100 Base-T Ethernet port. This

method allows you to use a Telnet session. Ethernet is also

ideal for controlling multiple Quadra units from a single

control point.

Please continue with the “System Control Setup

” section.

Note Analog display devices must be able to accept RGB inputs

of at least 15 kHz.

Note A PC can be connected directly to the Quadra’s Ethernet

port, without being connected to a network. For this “peer-

to-peer” method, an Ethernet crossover cable is required.

In Appendix C, refer to the “Ethernet Connector

” section

for pinout details.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 131 132

Commentaires sur ces manuels

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 23

Commentaires sur ces manuels