Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 27)

INSTALLATION AND SETUP

System Timing

350-7951 Quadra User’s Guide 19

. . . . .

With the IP address and port properly entered, the Telnet window

opens and Quadra responds with the product name and copyright

notice as shown in the sample below.

Figure 2-5. Quadra

4. To confirm the connection, in the Telnet window type:

… and press Enter. Quadra responds with a variety of product details

including the unit’s IP settings.

You can now control Quadra directly by issuing ASCII commands

from the Telnet terminal. Refer to Chapter 4, “Command Line

Interface” for a complete command list.

5. Please continue with the “System Timing

” section.

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

SYSTEM TIMING

The following topics are outlined in this section:

• Introduction to Timing

• Output Timing

• Advanced Output Timing

• Input Timing

INTRODUCTION TO

. . . . . . . . .

TIMING

For the best visual results with Quadra, the timing parameters of a signal must

match the display device. Please note:

• For each of Quadra’s four output channels, each channel’s output

settings should match the connected display.

• For each of Quadra’s four graphics inputs, Quadra’s input settings

should match the characteristics of the input signals.

Note To close a Telnet session, type EXIT or use the keystroke

sequence “Control + D.”

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 131 132

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 27