Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 31)

INSTALLATION AND SETUP

System Timing

350-7951 Quadra User’s Guide 23

. . . . .

Additionally, users must “exit” the interactive timing mode before normal

command line interface functions can be issued.

Use the following steps to adjust output timing interactively:

1. For the selected output channel and display, ensure that you’ve fol-

lowed steps 1 through 9 in the preceding “Output Timing

” section.

2. Turn on the “Grid” test pattern:

TP <output #> GRID Enter

3. For the selected output channel, begin the interactive output timing

procedure. Type:

OPTMINT <output #> Enter

A white box appears on the display.

4. Starting with the upper-left corner of the white box, use the keyboard

controls listed below to position the top left corner of the box at the top

left corner of the display monitor. Note that these adjustment

commands are case sensitive.

i = move up j = move left

m = move down l = move right

The goal is to position the upper left corner for maximum image

visibility, or for multi-display device configurations, to position the

corner to precisely match the position of the image on adjacent display.

5. With the upper-left corner properly adjusted, use the keyboard controls

listed below to position the bottom right corner of the box at the

bottom right corner of the display monitor.

I = move up J = move left

M = move down L = move right

The goal is to position the bottom right corner for maximum visibility,

or for multi-monitor configurations, to position the corner to precisely

match the position of an adjacent monitor image.

6. To exit the function, type q. This returns the system to the “normal”

command mode of operation.

7. Repeat steps 2 through 5. This repetition is necessary to accurately

fine-tune the timing parameters.

8. Use the Output Timing Name function to name the new “custom”

timing parameters — up to 23 alphanumeric characters in length.

Spaces are not allowed in the name, but underscores and upper/lower

case characters are OK.

Note These commands are all lower case.

Note These commands are all upper case.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 131 132

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 31