Rgb-spectrum Quadra User's Guide Manuel d'utilisateur télécharger pdf (Page 80)

COMMAND LINE INTERFACE

Command Summary

350-7951 Quadra User’s Guide 72

. . . . .

SERIAL PORT

. . . . . . . . .

COMMANDS

Serial Port Commands are used to control the baud and echo settings. A

summary is listed below. Click the desired command to access detailed

instructions.

Refer to the “Serial Port Commands Descriptions

” section for a complete

description of all serial port commands.

SERIAL PORT COMMANDS DESCRIPTIONS

The table below lists all serial port commands, their arguments and detailed

descriptions.

Table 4-10.

Serial Port Commands Summary

Command Description

BAUDrate

Sets the serial port baud rate.

ECHO Turns the serial echo On/Off.

HANDShaking

Sets the flow control mode.

Table 4-11. Serial Port Commands Descriptions

Command Arguments Description

BAUDrate [9600 | 19200 | 38400 |

57600 | 115200]

Sets the serial port baud rate. The value is

automatically saved in NVRAM.

Default: 9600

ECHO [ON | OFF] Turns the serial echo On/Off. The value is saved

in the NVRAM. The echo is only present on

commands typed and sent to the unit from the

serial port. There is no echo on a Telnet

connection.

Note: The Echo setting has no effect on

responses issued by the

Quadra; responses are

always visible, regardless of the echo status.

Default: ON

HANDShaking [HW | SW] Sets the flow control mode for the serial port.

• The HW option provides hardware

handshaking.

• The SW option provides for software

XON/XOFF flow control.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 131 132

Commentaires sur ces manuels

Pas de commentaire

Rgb-spectrum Quadra User's Guide Manuel d'utilisateur Page 80

Commentaires sur ces manuels